Install your VSS on a cubby or flat surface.

Tools Needed:

• Drill or Impact driver with a #2 Phillips bit

• Measuring Tape recommended

• Pencil recommended

Step 1

Mark where you want your hooks

Step 2

Screw your hook in. Make sure you have at least 3/8 thick material for optimal retention

Step 3

Tie knot at one end of the bungee. A regular overhand is fine. Dress it (tighten it)

Step 4

Hook the bungee into the farthest to reach hook.

Step 5

Run the bungee through all your hooks. We recommend a Zig Zag.

If you are planning on storing larger items, it is helpful to have those items in place to account for bulge.

Step 6

Locate where the last hook intersects the bungee. Choke up a few inches to add tightness. Tie a knot there.

Do not cut the bungee yet

Step 7

Test your setup with your gear. Move the knot of needed.

Step 8

Once you are ready, cut the bungee behind the knot and cauterize with a lighter. Please do this in a well ventilated area and be careful to not catch your bungee on fire.